A garage floor takes more punishment than most people expect. Hot tyres, oil and fuel drips, brake fluid, dropped tools, grit and constant temperature swings all land on bare concrete, which stains, dusts and wears quickly.
A premium epoxy garage floor fixes that, but only if it’s done properly. The finished look gets the attention, but what decides whether the floor is still performing in ten years is the system, the preparation and the installation behind it.
We bring the same flooring-grade systems and preparation standards we use on commercial and industrial sites across Perth and WA to a limited number of garage projects, where quality matters more than speed.
Premium doesn’t have to mean plain. Our flake flooring systems add colour and texture while keeping the full durability of the resin system underneath, and the mottled finish is good at hiding dust and minor scuffs. Colour blends range from subtle, neutral tones to bold contrast, and a non-slip texture can be built in where you want extra grip.
Most failed garage floors, including peeling, bubbling and flaking, come down to the same problem: a coating applied over concrete that wasn’t prepared properly. A garage slab can hold moisture, residual oil and old sealers, and a floor installed over those without treatment won’t last. Every project starts with grinding, repair and testing, so the system bonds to sound concrete and stays that way.
There’s a big difference between a flooring specialist and a contractor who paints floors. We install epoxy and resin systems for a living, with over 20 years’ experience across demanding commercial and industrial sites, and that same knowledge goes into every garage we take on. You don’t need to understand resin chemistry, because we recommend and install the right system for how you use the space.
DIY kits are typically thin, paint-style products applied over minimally prepared concrete, so they often peel or lift, especially under hot tyres. A professionally installed system is built to real thickness over a properly ground and tested slab, which is what gives it lasting performance.
Hot-tyre pickup is a known issue with thin or incorrectly specified coatings. A correctly specified, properly bonded flooring system is designed to resist it, which is why system selection and preparation matter.
Timing depends on the size of the garage, the condition of the slab and the system chosen. Preparation, repairs, base coats and sealing all take time to cure correctly, and we’ll give you a clear timeline once we’ve assessed the floor.
It can be if it isn’t specified for the conditions. A non-slip texture can be built into the system, so you get grip when the floor is wet without making it hard to clean.
Often, yes, once it’s been properly assessed. Cracks and damage are repaired first, and old sealers and surface contamination have to be removed so the new system can bond. We’ll tell you plainly what the floor needs.
